Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterTherma-Tru Door Installation: The Homestead Owner’s Guide
Therma-Tru door installation in Homestead typically runs $380 to $1,100 installed depending on the model line and what failed around it, and we complete most single-door installs in one visit. The part most owners call us about isn’t actually the door slab itself; it’s the frame, threshold, or weatherstripping that quit doing its job after years of South Florida humidity and storm season. You’ll usually notice it as a door that suddenly binds at the top corner in August, daylight showing under the sweep, or a threshold that’s started to rot from sprinkler overspray.
Which Therma-Tru Models This Applies To
Therma-Tru builds doors under several lines, and the installation details change with each one. The Classic-Craft and Fiber-Classic lines use a fiberglass skin over a polyurethane core, while Smooth-Star is their entry-level fiberglass and Pulse is a newer composite that’s lighter but has different hinge prep. What matters for a Homestead install is that Therma-Tru doors are ordered pre-hung with their own frame system, which means the slab, jambs, and threshold are designed as a matched set. Mixing a Therma-Tru slab into an older wood frame from another brand is where we see problems, especially in Homestead where the groundwater table keeps slab moisture high and the air salty enough to corrode hardware faster than inland. TruePane Windows & Doors is an independent service provider, not affiliated with Therma-Tru, but we install their products regularly and keep the common trim, thresholds, and weather seal kits on the truck for Classic-Craft and Smooth-Star models.
Signs Your Therma-Tru Door Installation Is Failing
- The door sticks at the top latch-side corner only in summer. That’s the fiberglass skin expanding in heat and humidity against a frame that was set too tight. The fix is re-shimming, not planing the slab; you can’t plane fiberglass the way you can wood without ruining the skin.
- You can see daylight under the door sweep. The adjustable sill cap on Therma-Tru thresholds has probably settled or the cap screws have stripped out. Water follows daylight, and in Homestead’s rainy season that means water on your floor every afternoon storm.
- The bottom corner of the frame feels soft when you push a screwdriver into it. This is frame rot, almost always from a threshold that wasn’t caulked at the exterior joint. On a slab home in Homestead, water wicks up through the sill and sits in the jamb.
- The door swings open or closed on its own. The hinges are out of plane, usually because the frame has settled and the original shim points have compressed. It’s not a ghost; it’s gravity working on a frame that’s no longer square.
- You hear wind whistling around the weatherseal even with the door latched. The compression seal on Therma-Tru doors loses its spring after about eight to ten years in Florida heat. The replacement is a specific profile matched to your frame, not a generic foam strip from the hardware aisle.
Replacement Cost & What’s Included
Here’s the honest price picture for Homestead, based on the installs we’ve done across neighborhoods from Leisure City to Princeton to the Redland:
| Scope | Installed Price Range |
|---|---|
| Threshold replacement and re-seal | $280 - $440 |
| Frame re-shim and re-square (no new slab) | $320 - $520 |
| Complete pre-hung Therma-Tru door install (standard size) | $650 - $1,100 |
| Complete pre-hung Therma-Tru door install (custom size or impact-rated pick-up in price) | $1,100 - $1,800 |
Every quote is written line-item before work starts. Part cost, labor, and any disposal are separate lines so you see exactly what you’re paying for. The Done Right Promise covers the install itself; the Therma-Tru manufacturer warranty gets registered in writing before the truck leaves your driveway. Both warranty layers, durations stated, no fine print that covers neither.
DIY or Call Us?
You can check two things without touching a tool. First, put a level on the top jamb and both side jambs to see if the frame has gone out of square. Second, run your hand along the weatherseal and feel for flat spots or tears. What you shouldn’t do is pull a pre-hung Therma-Tru unit out of its rough opening yourself. The door, frame, and threshold are one matched assembly, and if the rough opening has settled or has water damage, a new unit dropped into a bad opening fails the same way in two years. The work involves shims behind the jamb in specific load points, flashing at the sill, and re-caulking the exterior brickmold, and doing that wrong in Homestead’s wet season means rot behind the frame where you won’t see it until the wall opens up. If you’d rather have it done once, call (448) 428-7290 and we’ll measure, quote, and install it straight.
FAQs
The slab itself will go 25 to 30 years in Homestead’s climate; the threshold and weatherseal are the first things to go, typically at 8 to 12 years because of heat, rain, and UV exposure. We replace far more thresholds and frame components than full doors. Call (448) 428-7290 for an exact assessment of your door, and the estimate is free.
Often yes, if the rot is isolated to the bottom few inches of the jamb and the rest of the frame is still square and sound. If the rot has spread into the rough opening or the frame is out of plane, a full re-install is the money well spent, and we’ll tell you which before any work is scheduled.
A standard pre-hung install with an undamaged rough opening runs four to six hours; a frame rebuild or threshold replacement is usually two to three hours. We’ll give you a written time range on the quote and we’ll be there when we say.
We carry the common Therma-Tru thresholds, compression seals, hinge sets, and astragals for Classic-Craft and Smooth-Star lines, and we also stock parts for PGT, CGI, and CWS door systems. If your door needs a part we don’t have on hand, we order it as a direct OEM match, not a knockoff.
If you’ve got a Therma-Tru door in Homestead that’s sticking, leaking, or just not closing the way it should, call TruePane Windows & Doors at (448) 428-7290. We’ll send a background-checked, uniformed technician to measure the opening twice and give you a written quote with both warranty layers spelled out. That’s the only way Dale Kessler has ever done it: if it’s not in writing, it’s not a promise - it’s a sales pitch.
Written by Dale Kessler, Owner, TruePane Windows & Doors at TruePane Windows & Doors, serving Homestead and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.