Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
Sliding glass doors
Impact garage doorsPGTCGI
Before
After
Before
After
Before
AfterPGT Roof Repair in Homestead: What to Know First
PGT roof repair in Homestead typically runs between $350 and $1,800 depending on whether we’re sealing a leaking skylight curb, replacing a damaged roof-to-wall flashing detail, or resetting a PGT WinGuard or PGT Premier sliding glass door that has shifted out of square because of movement in the roof structure above it. Most jobs take one visit and are quoted in writing before any work begins. We’re an independent PGT service provider, not a factory warranty center, and we don’t charge for a second opinion.
If you’ve got a roof leak that’s finding its way down around a PGT window or door, or you’re seeing daylight where the roof meets the framing, call us at (448) 428-7290. We’ll put a live person on the line, ask the right questions, and get someone to your house with a ladder and a moisture meter.
How PGT Products Fail - and How We Fix Them
- PGT WinGuard vinyl windows under a sagging roof overhang: We regularly see WinGuard frames that have bowed at the header because the roof framing above them settled after Andrew-era patching. The window itself is fine, but the load transfer from the roof is pushing down on the frame channel and breaking the seal at the top corners. Our fix is to relieve the roof load point, re-square the frame, and re-seal with the correct structural adhesive, not a bead of hardware-store caulk.
- PGT Premier Sliding Glass Doors binding after roof movement: When the roof plane shifts, the door header rotates a few degrees, and a Premier slider that used to glide starts dragging at the strike side. Homeowners in Homestead who’ve lived through a few wet-dry cycles know this one. We reset the header, shim the frame back to level and plumb, and replace the roller assemblies if they’ve been chewed up by the bind.
- Curbside skylight leaks around the PGT fixed-panel framing: Roofers will sometimes flash up to a PGT fixed window or skylight panel but leave the upper corners vulnerable because the factory weep system is covered by membrane. Water sits there after a summer squall, wicks into the frame, and shows up as a brown stain on the interior drywall months later. We strip the flashing, rebuild the curb with proper step flashing, and re-install the panel so the PGT weep channels actually drain.
- PGT StormBreaker Plus impact door transoms tied to roof-wall intersections: A transom window over a StormBreaker Plus door is a common leak point when the roof-to-wall flashing above it was installed by someone who never looked at the door’s rough opening. The symptom is water on the deadbolt, not the glass. We re-flash the head of the opening and re-tap the frame so the water runs down the exterior face, not behind the WRB.
- Corroded fasteners where roof-runoff constantly hits the PGT frame: Homestead’s rainy season means sustained water contact on any fenestration product near a gutter end or valley. We find the original anchor screws rusted, the frame creeping away from the rough opening, and the PGT glass pack settling. We pull the fasteners, replace with stainless or coated hardware where the code calls for it, and re-bed the frame, then verify the drainage plane above the unit is carrying water away from them instead of onto them.
Our PGT Roof Repair Process
- 1
Call and diagnostic visit: You call (448) 428-7290. A live person answers. We schedule a time and show up in uniform, with a background-checked tech who measures the opening twice and photographs everything before touching a fastener.
- 2
Structural read: We trace the water path from the roof down to the top of the PGT frame. If we need to open the interior, we tell you first and show you why. We don’t cut drywall without your say-so and a reason.
- 3
Parts decision: We show you OEM PGT components alongside quality approved aftermarket parts with prices side by side on paper. If the aftermarket part is equal or better for your situation, we say so. If the job warrants an OEM replacement, we recommend that and explain why. No surprises, no change orders mid-job.
- 4
Repair work: We do the repair clean, re-flash where the roof meets the window or door, re-seal with materials rated for the South Florida exposure, and torque every fastener to spec.
- 5
Water test: We run water across the repaired area with a hose for at least 15 minutes, then inspect from the interior with a moisture meter. If there’s any moisture, the job’s not done.
- 6
Paperwork: You get a written line-item invoice, the fix is registered, and it’s covered under our Done Right Promise. If it leaks again in 90 days, we make it right, no arguing.
What PGT Roof Repair Costs in Homestead
Here’s what we charge in Homestead for the most common PGT roof repair scenarios, straight from our written estimates:
| Job | Typical Range | What Moves the Price |
|---|---|---|
| Re-flash and re-seal a PGT window or door head | $350 - $650 | Access height, stucco repair extent, existing flashing condition |
| Fix a leaking skylight curb with PGT fixed panel | $600 - $1,200 | Curb rebuild vs. simple flashing repair, number of panels |
| Re-square and reset a PGT Premier sliding door affected by roof movement | $500 - $950 | Framing adjustments needed, roller replacement, header shimming |
| Replace corroded fasteners and re-bed a PGT frame at roof-runoff zone | $250 - $500 | Number of fasteners, damage to surrounding stucco, access |
Every estimate is line-itemed in writing before we start. You’ll see the exact number for parts, the exact number for labor, and the warranty terms. We don’t do rough ballparks that become surprise invoices. Call (448) 428-7290 and we’ll give you a straight answer.
Why Homestead Homeowners Call TruePane Windows & Doors for PGT Work
We’ve been at this in Homestead since 2008, and Dale Kessler has been running TruePane since 2008. That matters because we’ve seen what happens when a company installs a PGT product correctly and walks away, versus one that slaps it in and disappears. We’ve come behind enough botched jobs to know the difference.
Every PGT window or door we touch is covered by our Done Right Promise. If it’s not done right, we make it right, in writing, with no paperwork fights. And if a PGT product is beyond repair or its replacement comes up in the estimate, we can quote you side by side on other impact-rated lines we service, including CGI, CWS, ES Windows, and ECO Window Systems. That’s a square deal: two or three price points, all with both warranty layers registered before we leave the driveway.
FAQs
It can, if the repair involves non-OEM parts or methods that alter the factory integrity of the product. That’s why we show you OEM and approved aftermarket parts side by side before any work is done, and why we follow the installation and repair specs that PGT publishes. As an independent PGT service provider, we can’t make warranty determinations on PGT’s behalf. But we document every repair so you have a written record to take to the manufacturer if needed. Call (448) 428-7290 and we’ll walk you through what we found.
We answer every call live, 24 hours a day, 7 days a week. When you call about a water leak above a PGT window or door, we treat that as time-sensitive because water and framing don’t wait. We’ll schedule the diagnostic visit at the earliest slot we have, and if it’s an active leak we’ll do everything we can to get a tarp up or temporary flashing installed the same day. You reach a person when you call (448) 428-7290. Not a voicemail, not a call-back form.
Re-caulking the joint where the roof flashing meets the PGT frame will buy you a few weeks at best if you’ve got in a frame leak, and it does nothing at all if the real problem is roof movement or a failed curb. The water that’s already inside the rough opening keeps working on the framing and the window anchors. You’ll wind up calling us anyway, and paying to fix the original leak plus the newer water damage. We’d rather give you an honest look and a written estimate before you spend money on a temporary fix.
Most roof repair at the window or door header is maintenance and doesn’t require a permit, but when the repair crosses into structural framing or flashing that’s tied to the roof system, the City of Homestead building department may need to be involved. We check the scope against the current Florida Building Code before we write the estimate, and we’ll tell you upfront whether a permit is needed, who pulls it, and what it costs. No change orders after the fact.
Dale Kessler grew up in Naranja, just a few miles north of downtown Homestead, and spent enough summers boarding up windows before hurricane season to decide he’d rather install ones that didn’t need it. He learned the trade at Miami Dade College’s Kendall Campus and has spent more than a decade running TruePane out of Homestead. When our techs show up to your house, they’re background-checked, uniformed, and trained to treat your PGT windows and doors as if the warranty registration matters, because it does. And our Done Right Promise is written, not spoken. If it’s not in writing, it’s not a promise - it’s a sales pitch.
Written by Dale Kessler, Owner, TruePane Windows & Doors, serving Homestead and nearby areas.
Six Reasons Homeowners Choose TruePane Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.